-
Harvest cells from a culture which is at or near peak density by adding 5 mL fresh ATCC medium 1323 (Pages Balanced Salt Solution) and washing cells into suspension.xa0 Rub the surface of the plate with a spread bar to detach adhering amoebae.
-
Transfer the liquid medium to a sterile centrifuge tube.
-
If the cell concentration does not exceed 2 x 106 cells/mL adjust the suspension to that concentration.xa0 To adjust the concentration, centrifuge at 600 x g for 5 min and resuspend the pellet in the volume of fresh medium required to yield 2 x 106.
-
While cells are centrifuging prepare a 15% (v/v) solution of sterile DMSO as follows: Add the required volume of DMSO to a glass screw-capped test tube and place it in an ice bath.xa0 Allow the DMSO to solidify.xa0 Add the required volume of refrigerated medium.xa0 Dissolve the DMSO by inverting the tube several times.
*NOTE: If the DMSO solution is not prepared on ice, an exothermic reaction will occur that may precipitate certain components of the medium.
-
Mix the cell preparation and the DMSO in equal portions. Thus, the final concentration will be at least 106 cells/mL and 7.5% (v/v) DMSO.xa0 The equilibration timexa0 (the time between addition of DMSOxa0 and the start ofxa0 the cooling cycle) should be no less than 15 min and no longer than 60 min.
-
Dispense in 0.5 mL aliquots into 1.0 - 2.0 mL sterile plastic screw-capped cryules (special plastic vials for cryopreservation).
-
Place vials in a controlled rate freezing unit. From room temperature cool at -1°C/min to -40°C. If freezing unit can compensate for the heat of fusion, maintain rate at -1°C/min through heat of fusion. At -40°C plunge ampules into liquid nitrogen.
-
The frozen preparations are stored in either the vapor or liquid phase of a nitrogen freezer.
-
To establish a culture from the frozen state place an ampule in a water bath set at 35°C (2-3 min). Immerse the vial to a level just above the surface of the frozen material. Do not agitate the vial.
-
Immediately after thawing, aseptically remove the contents of the ampule and distribute to the center of a fresh plate of ATCC medium 711.xa0 Distribute the material evenly over the plate using a spread bar.xa0 Incubate at 25°C.